DirectInput not functioning
From: markmotion
Date: Sun, 3 May 2009 15:07:01 -0700

I have a problem running some graphics applications and some games.
Looking at DxDiag, I see the following error reported:

"DxDiag has determined that there may have been a problem accessing
DirectInput..."

I then did a lot of testing to see what might be causing DirectInput to
choke, and disabled sets of services until I found that DirectInput ran just
fine when Microsoft Plug&Play was not loaded. Only disabling P&P alllowed
DirectInput to operate just fine after rebooting (of course disabling P&P
cripples the computer to a near-nonfunctional state itself, so that's
impractical)

I understand that the problem might not be with Plug&Play itself, but with
one of the many drivers that P&P loads.

How do I see what P&P is handling specifically so that I can isolate
whatever is causing problems with Plug&Play and thereby problems with
DirectInput?

And if I am incorrect in my assumptions, please don't hesitate to say so!

thanks in advance!
[Reply] RE: DirectInput not functioning
From: Andrew E.
Date: Sun, 3 May 2009 21:34:09 -0700

  Try run,type:services.msc  In msc,scroll to plug & play,double click,click on
the dependicies tab,the other services that use plug & play will be listed.
Also,open event-viewer,scroll thru,youre bound to see "Events/Warnings"
related to youre problem(s)..

"markmotion" wrote:

replated replys:
   Root
      863317.


Was this post helpful to you?.